No Start Condition driving me Crazy
No Start Condition driving me Crazy I have a 2000 Firehawk with a few bolt ons. The car developed a no start condition where it will turn over but not fire. I have checked the air intake for leaks, I unplugged the MAF to see if it went bad, I replaced the Cam and Crank sensors. I tried to visually inspect the wires and didn't see any issues with them. I inspected all the spark plugs and coil packs, and the fuel pressure. The weird thing is if I disconnect the battery and let the PCM completely die it will start right up and run perfectly for about 4 starts or so. Then it seems like when the computer re-learns the starting issue comes back. None of the stuff I looked at fixed the problem. Does anyone else have any suggestions I don't know what else to try. I've spent probably 15 hours trying to fix this and I feel like a total failure. 
TECH Addict
Joined: Dec 2001
Posts: 2,907
Likes: 1
From: Bergen County, NJ
None of the things you list would cause it not to start. Check your ignition relay as stated, check and clean your grounds, and BTW, you can reset the PCM without disconnecting the bettery - do a search on the procedure.
No codes, I will search on the reset procedure and relay. Thanks.
I checked all that other stuff because it was on this checklist:
http://www.hotrodlane.cc/New%20LS%20...0Not%20Run.htm
I checked all that other stuff because it was on this checklist:
http://www.hotrodlane.cc/New%20LS%20...0Not%20Run.htm
Thank you very much for the help though. 
