LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

ARP head stud torque?

   
Old Dec 17, 2009 | 03:02 AM
Share
  #1  
2002RamAir's Avatar
2002RamAir
Thread Starter
TECH Regular
iTrader: (19)
 
Joined: Nov 2004
Posts: 493
Likes: 0
From: Charleston, SC
Default ARP head stud torque?
Can someone tell me what the top little studs on the heads get torqued to? I did 32lbs. Will that be fine or is it more?
Reply
0
Old Dec 17, 2009 | 05:23 AM
Share
  #2  
vettenuts's Avatar
vettenuts
TECH Senior Member
iTrader: (4)
 
Joined: Jul 2004
Posts: 8,092
Likes: 13
From: Little Rhody
Default
That's actually too much and you are lucky they didn't break. 23 lb-ft is what I was provided by ARP. Back them off one at a time in the correct order then re-tighten to the lower value.
Reply
0
Old Dec 17, 2009 | 11:26 AM
Share
  #3  
tom falco's Avatar
tom falco
Launching!
 
Joined: Jun 2009
Posts: 268
Likes: 1
Default
They are over tightened according to ARP. Leave them alone and dont mess with them. If they did not sheer you lucked OUT
Reply
0
Back to Subforum
Generation III Internal Engine
View Next Unread
Any f-body in south florida!!!!!


Thread Tools
Search this Thread
Search this Thread:

Advanced Search

Advanced Search

All times are GMT -5. The time now is 01:31 PM.