stroker kit?
03-14-2010, 11:07 PM
#1
Teching In
Thread Starter
Join Date: Dec 2009
Location: broken arrow, ok
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
stroker kit? ive got a few ls1's and some people say 383 and some say 408..? im not realy sure what can be done with a ls1 for a stroker kit? any help and info please
03-14-2010, 11:47 PM
#3
Teching In
Thread Starter
Join Date: Dec 2009
Location: broken arrow, ok
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
what do i get the cranks from? im new to the ls.. im used the old small block where i just get a crank from s sb400 and get some nice 6" rods and build a nice 350block up... so im alil confused on the ls's
03-15-2010, 02:02 AM
#4
12 Second Club
iTrader: (1)
Join Date: Aug 2008
Location: hammond,la
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
The 408 would need a 6.0 block. If i were you id save up and buy a built short block. If not you can get the crank, rods, and pistons from any of the sponsors on this site.
03-15-2010, 09:38 AM
#5
alot of sponsors sell complete Kits, I would look into Texas Speed and performance kits, I have spend alot of money with them and they have always been super.
On a side note one benefit of going with a 383 which is what I have done, is it is about 80LBS lighter than a 408. Keeping the aluminum block. Unless you go the 408 with an LS2 block,,, $$$$
On a side note one benefit of going with a 383 which is what I have done, is it is about 80LBS lighter than a 408. Keeping the aluminum block. Unless you go the 408 with an LS2 block,,, $$$$