heads and cam combo
Thread Starter
Teching In
Joined: Jul 2009
Posts: 20
Likes: 0
From: Clarksville Indiana
heads and cam combo i have a sleeved 427 stroker and wondering what heads and cam would be best i would like achieve around 600 hp all motor plan on a 250 shot on it. any advice?
Last edited by 98nxz28; May 6, 2010 at 06:53 AM.
If you have a 4.100" bore or larger then you should seriously look into a set of ported LS7 heads. They flow extremely well and when set up with the right cam it is possible to hit the 600rwhp mark in a 6spd car.
I agree with the above statment or you could get a set of ETP 245cnc or TEA TFS 235CNC heads for that bad boy, if money isn't an option of course.. As far as the cam goes I would have a cam guru like Allan Futral, Patrick G, ED Curtis, etc. just to name a few to customs spec you a cam for your requirments.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo I would recommend going with the TFS 235cnc heads. I have the TFS 215cnc heads on my stock bottom end 346ci LS1 and have been able to dip into the 10's on a normal basis. Again good luck with your search man.
Thats not too much head for that large an engine and they move some serious air.
The area under the curve is explosive.....over 290 CFM as early as .400 lift....its a serious piece.
PM or call should you have any questions....
-Tony
(661)705-8508
