k1 billet lightweigt rods
Thread Starter
TECH Fanatic
iTrader: (70)
Joined: Oct 2005
Posts: 1,219
Likes: 0
From: Los Angeles, California (818)
k1 billet lightweigt rods has anyone had any experience with k1 billet lightweight rods?
they seem like good quality and the price is definately right.
any info appreciated.
they seem like good quality and the price is definately right.
any info appreciated.
Are you talking about their lightweight (CH6125ALLB-LSL8-A) or supreme lightweight (CH6125ALLB-LSSL-8)?
I'm building my new LS3 with the LSL8's. Tom Molnar at K1 says the supreme light rods need a piston <430g, must not be used on blown/NOS motors, and the motor should be less than 550HP (I presume at the engine). Price is the same as their normal lighweight piston.
I'm building my new LS3 with the LSL8's. Tom Molnar at K1 says the supreme light rods need a piston <430g, must not be used on blown/NOS motors, and the motor should be less than 550HP (I presume at the engine). Price is the same as their normal lighweight piston.
