Best valves for this setup?
Thread Starter
TECH Addict
Joined: Dec 2001
Posts: 2,337
Likes: 0
From: Auburn, AL
Best valves for this setup? I may have a set of slightly used 2002 LS6 valves. I am building up a set of heads for a truck 5.3 motor.
Patriot Stage I 5.3 heads milled .040"
I want to run a 2.0" intake and 1.55" exhaust valves.
I may run nitrous in the future, which is why I was wary about the LS6 valves. I don't want to burn a valve. It will not be over a 150 wet shot, though.
I was looking at going with Ferrea valves if I don't go with the LS6 ones. I imagine the LS6 valves would be best for power/reliability because of their weight. Any ideas?
Patriot Stage I 5.3 heads milled .040"
I want to run a 2.0" intake and 1.55" exhaust valves.
I may run nitrous in the future, which is why I was wary about the LS6 valves. I don't want to burn a valve. It will not be over a 150 wet shot, though.
I was looking at going with Ferrea valves if I don't go with the LS6 ones. I imagine the LS6 valves would be best for power/reliability because of their weight. Any ideas?
Last edited by quickWS6; Jan 15, 2004 at 09:55 AM.
