Milling 243 heads
Thread Starter
Teching In
Joined: Apr 2009
Posts: 22
Likes: 0
Milling 243 heads My 243 heads are ported and milled down to 62cc cambers.
And I have a 283 stroker kitt with 8.5 C/R on 64 cc heads.
The engine will be supercharged.
BUT one of the heads have a small dent. And I was thinking of shaving a bit off the heads to remove it.
How much can I take? How much is taken to bring it down to 62cc?
I can go up to 9 in C/R, but what deck thickness is safe?
How do I measure deck thickness, and whats the limmit?
And I have a 283 stroker kitt with 8.5 C/R on 64 cc heads.
The engine will be supercharged.
BUT one of the heads have a small dent. And I was thinking of shaving a bit off the heads to remove it.
How much can I take? How much is taken to bring it down to 62cc?
I can go up to 9 in C/R, but what deck thickness is safe?
How do I measure deck thickness, and whats the limmit?
Last edited by Mar10n; Nov 24, 2010 at 06:49 AM.
