Ok putting in my torquer v3 in next week with stock 241 heads. Pushrod length checker is on the way....but what numbers can i expect to be around? 7.4? 7.375? Just wanna make sure im in the ballpark.

 

If checker is on the way, measure and purchase after you have done so.

 

With that cam I ran a 7.400 in my old ls1 stock heads/lifters/rockers

 

Definitely measure but on an otherwise stock motor I would expect 7.425". If you're measurement is in that ballpark, you will be fine. If it is drastically different one way or the other, you know you are doing something wrong on the measurement. But I definitely agree to measure before so you only have to purchase pushrods once!

Jon

 

very cool thanks. Very excited to get this thing running