i think i run into a problem.here is what i have.
stock bore lq4
stock lq4 crank
ordered 6.100 length rods but 6.125 rods come in
wiseco k447xs http://www.wiseco.com/Catalogs/Automotive/Chevrolet.pdf
sdpc cnc ls3 heads decked .030
.040 compressed head gaskets

i would like to know if i am going to have problems with the rods being to long?should i send the rods back for 6.100 or maybe go back to stock head gasket?

any input or help is greatly appreciated.

 

Actually, you lucked out. You need the 6.125" rods with the K447xs pistons. You can stop stressing.

 

ok good. i was scared because on the wiseco website it listed both rod lengths and i thought because i an using a stock stroke crank the piston will come out of the block a lil bit. thanks for the help