is my method for measuring pr length ok
Thread Starter
Staging Lane
Joined: Jan 2009
Posts: 88
Likes: 0
From: south dakota
is my method for measuring pr length ok sorry i know this topic is beat to death on this forum, however i have searched and read many threads and even books i am simply posting to make sure i understand this method of checking. first of all i am using the comp cams length checker. my setup constists of torquer v3 cam stg. 2.5 ls6 heads milled .020, ls7 lifters stock trunion upgraded rockers.
1. align timing dots at 12 o' clock so cam is on base lobes for cylinder number 1
2. insert pushrod lenth checker and torque rocker arm to 22lb-ft
3. adjust pushrod length checker to 0 lash
4. add desired pre load to final measurement on pr checker
this is what i understand after searching. somebody please let me know if this is correct. thanks
1. align timing dots at 12 o' clock so cam is on base lobes for cylinder number 1
2. insert pushrod lenth checker and torque rocker arm to 22lb-ft
3. adjust pushrod length checker to 0 lash
4. add desired pre load to final measurement on pr checker
this is what i understand after searching. somebody please let me know if this is correct. thanks
sorry i know this topic is beat to death on this forum, however i have searched and read many threads and even books i am simply posting to make sure i understand this method of checking. first of all i am using the comp cams length checker. my setup constists of torquer v3 cam stg. 2.5 ls6 heads milled .020, ls7 lifters stock trunion upgraded rockers.
1. align timing dots at 12 o' clock so cam is on base lobes for cylinder number 1
2. insert pushrod lenth checker and torque rocker arm to 22lb-ft
3. adjust pushrod length checker to 0 lash
4. add desired pre load to final measurement on pr checker
this is what i understand after searching. somebody please let me know if this is correct. thanks
1. align timing dots at 12 o' clock so cam is on base lobes for cylinder number 1
2. insert pushrod lenth checker and torque rocker arm to 22lb-ft
3. adjust pushrod length checker to 0 lash
4. add desired pre load to final measurement on pr checker
this is what i understand after searching. somebody please let me know if this is correct. thanks
Thread Starter
Staging Lane
Joined: Jan 2009
Posts: 88
Likes: 0
From: south dakota
