What do you this of this setup
#1
TECH Apprentice
Thread Starter
Join Date: Feb 2009
Location: Harlingen, Tx
Posts: 313
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
What u think of this set up and what it will run.
My older setup
stock 853
bbk intake
p&p tb
TSP Lid
Lt's headers
TV2 cam 232/234 .595/.598 112lsa
Yanks ss4000
373 gears
UMI lca
shark nozzle 125 shot
RAN 11.9@112 1.65 60FT MOTOR AND ON SPRAY 11.5 @120 1.64 60FT(SPRAYON 2ND)
NEW SETUP
stock 243 heads (clean up on the ports)
F.A.S.T 78 intake ported the ports
F.A.S.T 78 tb
TSP Lid
Lt's headers
HPE S-cam 238/240 .605/.609
Yanks ss4000
4:10 gears
UMI lca
TNT F1 100 SHOT
My older setup
stock 853
bbk intake
p&p tb
TSP Lid
Lt's headers
TV2 cam 232/234 .595/.598 112lsa
Yanks ss4000
373 gears
UMI lca
shark nozzle 125 shot
RAN 11.9@112 1.65 60FT MOTOR AND ON SPRAY 11.5 @120 1.64 60FT(SPRAYON 2ND)
NEW SETUP
stock 243 heads (clean up on the ports)
F.A.S.T 78 intake ported the ports
F.A.S.T 78 tb
TSP Lid
Lt's headers
HPE S-cam 238/240 .605/.609
Yanks ss4000
4:10 gears
UMI lca
TNT F1 100 SHOT
#3
TECH Apprentice
iTrader: (34)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Looks like a good setup, should give ya some ponies over your previous set up, jus wanna add some advice if you dont mind I would mill the heads a little for more compression and also do a VJ/bowl blend, ud pulley, 85mm maf, and some type of ram air setup while not necesary these things will add a little more power and are not hard on the wallet!!!