Im looking to start up a new motor project. I was thinking of starting out with the 6.0 iron block, with a healthy bore and stroke. On top of that Id like to slap on a turbo or two and see what happens from there.

I was wondering if you guys could throw me some info on how to go about this, what would be a good bore/stroke to do, and still allow enough tolerances to run alot of boost. This will also be a street car seeing mostly track time but will still be driven on the street.

Im not looking to get this done this summer or anything, im just looking for a project to start and slowly finish....Im in no rush so time and money are not an issue.

Much appreciated.

Mark

 

hit up APE they can hook you up with a nice forged 409 (4.030 x 4.00) short/long block ready for boost