Livernois Heads

Reply Subscribe

Thread Tools

Search this Thread

Jul 3, 2013 | 08:19 AM

420gto

Thread Starter

Staging Lane

iTrader: (11)

Joined: Mar 2006

Posts: 77

Likes: 0

From: ATL

Livernois Heads

I was wondering if anyone knew the cc's off their stage 2 heads. I took a set to a local shop and they said the heads came back at 65cc so I wanted to see if anyone else had a set measured. Livernois' website says the heads are milled between .010-.015 so unless the 243's started out above 66cc's I can't see how this would be possible. I'm out of town and won't be able to get this sorted out in person until Fri, so any help in the meantime would be greatly appreciated.

Jul 3, 2013 | 08:22 AM

redtan

TECH Junkie

iTrader: (5)

Joined: May 2008

Posts: 3,764

Likes: 17

From: Belmont, MA

They could've ported/countoured the chamber thus opening it up a bit to say 66cc, then the milling brought it back down closer to OEM cc.

Jul 3, 2013 | 08:29 AM

420gto

Thread Starter

Staging Lane

iTrader: (11)

Joined: Mar 2006

Posts: 77

Likes: 0

From: ATL

Quote:

Originally Posted by redtan

They could've ported/countoured the chamber thus opening it up a bit to say 66cc, then the milling brought it back down closer to OEM cc.

I send Livernois a PM asking them about it as well. So I guess anything is possible. Once I get to the shop on Fri I will request they measure the cc's in front of me because this shop has been nothing but a hassle. They've had the heads for 2 1/2 weeks to be measured, flow tested, and cleaned. They did absolutely nothing for 2 weeks and gave me the run around as to why. I was out of town so my hands were tied. They finally did something on Mon but I seriously question the validity of their work at this point.