T&D Rocker install L92
Thread Starter
TECH Apprentice
iTrader: (5)
Joined: Oct 2007
Posts: 359
Likes: 0
From: New Hampshire
T&D Rocker install L92 I recently installed this system and wanted to share my experience
1. Heads come off for clearencing
2. I have .025 at least behind each rocker, on the valve cover rail side
3. Push rod holes must be elongated,(more like egg shape)
4.Follow T&D install instructions and get the correct stand height.....critical
5.You will need new valve covers and push rods
6. With the help of Booth Platt from Pro Form I was able to get there new slant edge covers to work with some minor grinding on the top rail. These new covers work well.
6. I have a few miles on the set-up now with no issues.
1. Heads come off for clearencing
2. I have .025 at least behind each rocker, on the valve cover rail side
3. Push rod holes must be elongated,(more like egg shape)
4.Follow T&D install instructions and get the correct stand height.....critical
5.You will need new valve covers and push rods
6. With the help of Booth Platt from Pro Form I was able to get there new slant edge covers to work with some minor grinding on the top rail. These new covers work well.
6. I have a few miles on the set-up now with no issues.
