What power number should I expect?
Thread Starter
TECH Regular
Joined: Apr 2011
Posts: 403
Likes: 0
What power number should I expect? I would love to hit 420whp
My plan is
Streetsweeper HT cam
http://www.flowtechinduction.com/fti...r-ht-camshaft/
Ls6 or fast 78 intake ( i have the ability to get either one for 350.00)
BTR Valvetrain
stock or handed ported 243/799 heads. milled .010. (could I mill with that cam?)
Texas speed longtubes, no cats, xpipe, stock mufflers for now.
CAI
Tune.
What would you guys say I should expect from those mods?
I had a 228R in a previous car and loved it for my DD. I never take my car to the track so driveability is huge for me. but I always felt like I could have been ok with a lil bigger than my 228 but not much
My plan is
Streetsweeper HT cam
http://www.flowtechinduction.com/fti...r-ht-camshaft/
Ls6 or fast 78 intake ( i have the ability to get either one for 350.00)
BTR Valvetrain
stock or handed ported 243/799 heads. milled .010. (could I mill with that cam?)
Texas speed longtubes, no cats, xpipe, stock mufflers for now.
CAI
Tune.
What would you guys say I should expect from those mods?
I had a 228R in a previous car and loved it for my DD. I never take my car to the track so driveability is huge for me. but I always felt like I could have been ok with a lil bigger than my 228 but not much
Last edited by Jarren_b; Dec 10, 2013 at 06:29 PM.
Thread Starter
TECH Regular
Joined: Apr 2011
Posts: 403
Likes: 0
We hand ported a set of 243s, milled them I think .025, stock gasket, and made 450 420 thru a 9 inch and a steal driveshaft with a stock ls6 intake.
Same cam made 415 400 in my old Z06 cam only.
It may not be a dyno queen cam, but it will hurt some feelings on the track and street.
Same cam made 415 400 in my old Z06 cam only.
It may not be a dyno queen cam, but it will hurt some feelings on the track and street.
