When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Trash or treasure, I took a chance on a timing chain damper on eBay. $50, and the description said it would fit Ls1-Ls6 gen III blocks without drilling/tapping. Just got it in today, and the quality seems pretty good. Also, it bolted right up to my 2002 ls1. Figured Id share.
wow, i have never see the inside of an LS motor that dirty. pitch black. how many miles u have on that thing? looks like a diesel motor
Considering this portion of the engine sits above the oil pan completely exposed to used oil as the motor runs, I'm not concerned at all. Did the previous owner need to change the oil more? It would appear so. 90k on the clock
Well I wouldnt be worried about timing chain tension as much as the sludge in the bottom end thats for sure.
Trust me, if I had the coin to tear down the short block/hot tank everything/hone/replace pistons and bearings and rods I would have already done it. I'm at the end of my build (4 months ago I didn't have a roller, engine, tranny or basic tools) and at this point the cash cow has officially died. The motor runs fine and only has 89k. If I spin a bearing I'll have a winter project.
I wish I saw this prior to the weekend lol. that trick flow bracket is a piece of junk spent and hour getting it straight and useable to my it didn't hit the oil pump
The engine dampener referenced above is one that I designed and had made. I have been working with a supporting vendor to carry them and I am happy to say they are now available through Brian Tooley Racing.
Hello Sgt Skid , I was wondering about that backet/damper You designed and built . I'm guessing that it's not made of metal and I'm not asking what. And also I am guessing again that it's thicker than it looks ? Am I at all in the ballpark ? And again I'm not asking You to disclose any info other than if I'm close at all ? Thank You and good luck for sure
SgtSkid disregard My post , I did'nt see the word bracket in You're description ,,,,,My bad
Last edited by chrisfrost; 06-15-2016 at 09:10 PM.
Reason: Misunderstood the description
The dampener pictured in the OP post is what he made. The bracket I posted is from Melling. We offer it. If your block does not have the holes you can either drill and tap and use any of the many tensioners, including the one pictured (we also offer the original style "white" tensioner that some of the LS blocks used) or use that bracket that I posted.