Compression help
Thread Starter
Teching In
Joined: Mar 2009
Posts: 7
Likes: 0
From: Alberta
Compression help Hey guys,
so I have a set of TFS220s as casts on the way with powdered metal guides touched up by btr. The question I have is if I should mill them 0.010 or not?
The cam is a BTR Stage 4 LS1 and have a set of cometic 0.04 gaskets. This is going on a stock bottom end LS1. I don't want to fly cut and I am keeping it on pump gas. Any help is greatly appreciated!
thanks
so I have a set of TFS220s as casts on the way with powdered metal guides touched up by btr. The question I have is if I should mill them 0.010 or not?
The cam is a BTR Stage 4 LS1 and have a set of cometic 0.04 gaskets. This is going on a stock bottom end LS1. I don't want to fly cut and I am keeping it on pump gas. Any help is greatly appreciated!
thanks
