Help with my compression ratio
Help with my compression ratio I know there's a post bout it at the top. My question is how much higher will the compression go when milled like .03 over. And it's on a 6.0 stock motor with dish pistons. It also has .06 notch for valve clearance. I have no clue how to figure out what the compression ratio would be. What would the cc would be with 99 heads milled, with the dish pistons. Anyone have this setup? I'm using the stock 6.0 liter gasket. There pretty thick. I've reused them 3 times so far, lol. Any help would be appreciated, thanks.
Srun
Srun
Originally Posted by NoseUpChromeDown
