What else needed for header / cam install
Thread Starter
On The Tree
Joined: Oct 2003
Posts: 196
Likes: 0
From: Louisville, KY / Memphis, TN
What else needed for header / cam install I am installing my kooks headers, TR 224 cam, lanes TDs soon this is what I have so far:
Kooks SS headers
TR224 Cam
Lanes 3in TD's
JWIS Timing Chain
ASP UDP + Bolt + Belts
TR ported Oil Pump
TR Hardened Pushrods
Comp 918 Valve Springs
NGK TR 55's + Taylor thundervolt wires
I also have new header gaskets, anything else I need? I am deleting AIR also....?
Kooks SS headers
TR224 Cam
Lanes 3in TD's
JWIS Timing Chain
ASP UDP + Bolt + Belts
TR ported Oil Pump
TR Hardened Pushrods
Comp 918 Valve Springs
NGK TR 55's + Taylor thundervolt wires
I also have new header gaskets, anything else I need? I am deleting AIR also....?
Launching!
Joined: May 2004
Posts: 275
Likes: 0
From: miami
you need the camswap gasket set, thunder has em. you need a torque wrench. check www.ls1howto.com they have a full write-up on it.
Thread Starter
On The Tree
Joined: Oct 2003
Posts: 196
Likes: 0
From: Louisville, KY / Memphis, TN
I already have a torque wrench for that, but thanks, I will order the gasket set! I dont mind spending the extra $$$ for items that will increase longitivity, because I expect to keep this car for a while!
