Anyone using the COMP 941 valvesprings?

Reply Subscribe

Thread Tools

Search this Thread

Mar 24, 2005 | 08:16 AM

DragLS1

Thread Starter

Staging Lane

Joined: Mar 2005

Posts: 94

Likes: 0

From: San Antonio Texas

Anyone using the COMP 941 valvesprings?

I would like to use the comp 941's. Does anyone else use these springs? The cam that I am going to use has .612" lift which puts me @ .010 away from coil bind at full lift at an installed height of 1.750". What retainers fit these springs? Do they fit into the stock spring cups at an O.D. of 1.260?

Thanks

Mar 24, 2005 | 09:08 AM

cyphur

TECH Senior Member

iTrader: (10)

Joined: Mar 2003

Posts: 8,009

Likes: 0

From: North Texas

why not run 921's. they're rated to .650.

Mar 24, 2005 | 09:37 AM

DragLS1

Thread Starter

Staging Lane

Joined: Mar 2005

Posts: 94

Likes: 0

From: San Antonio Texas

Quote:

Originally Posted by cyphur_traq

why not run 921's. they're rated to .650.

Well, the only reason that I don't want to use the 921's is because they cost right at 400.00. I think I found a set of crane springs that will work that are rated at .650" lift, but have slightly lower seat and open pressures. No problem though, I can shim them .030 and still be .010" away from the net rated max lift that crane recommends. And they are only 150.00.

Mar 24, 2005 | 10:42 AM

Unaffliated Racing

Registered User

iTrader: (15)

Joined: Nov 2002

Posts: 873

Likes: 1

It would probably be even better to run the 918 springs.

Reply Subscribe