ls1 to ls6 cam help
#1
11 Second Club
Thread Starter
Join Date: Dec 2004
Location: columbus, ohio
Posts: 196
Likes: 0
Received 0 Likes
on
0 Posts
ls1 to ls6 cam help
i have the opportunity to pick up a 03 ls6 cam, springs, retainers and pushrods for basically nothing
so heres my question, would it benifit me to change the springs and retainers or can i leave the stock ls1 springs/retainers on the car, and just change the cam and pushrod? is there anything i else i might need to change other than the cankbolt or front main seal?
so heres my question, would it benifit me to change the springs and retainers or can i leave the stock ls1 springs/retainers on the car, and just change the cam and pushrod? is there anything i else i might need to change other than the cankbolt or front main seal?
#2
TECH Enthusiast
Join Date: May 2004
Location: DFW/Waco, TX
Posts: 666
Likes: 0
Received 0 Likes
on
0 Posts
change the springs out as well,stock spring wont hold the ls6 cam. especially if your gettin everything for basicly nothing.
Last edited by 99CamaroSS_; 05-27-2005 at 06:51 PM.
#3
10 Second Club
iTrader: (15)
Join Date: Nov 2001
Location: St. Michael, MN.
Posts: 4,519
Likes: 0
Received 0 Likes
on
0 Posts
You need the LS6 valve springs. Installing the pushrods and retainers is up to you and are the same as the LS1. You will also need the crank bolt, front seal, timing cover gasket, water pump gaskets, new coolant.