cyl 6 missfire
#1
TECH Fanatic
Thread Starter
iTrader: (9)
Join Date: May 2005
Location: Longview, TX
Posts: 1,085
Likes: 0
Received 0 Likes
on
0 Posts
cyl 6 missfire
I did the coil relocation mod last night and now I have a missfire on cyl 6. I swapped spark splugs, wire, and coil with another cylinder and it stays at 6. How can I check for voltage to the coil? I have continuity in the coil harness, but I don't know if 6 is getting battery or signal voltage.
Oh yeah, I left my test light at work and all I have here is my DVOM.
Oh yeah, I left my test light at work and all I have here is my DVOM.
#2
TECH Resident
Join Date: Dec 2004
Location: K-W, Ontario
Posts: 845
Likes: 0
Received 0 Likes
on
0 Posts
You might have trouble getting a reading with a digital meter depending
on the sample speed.
Connect the meter just as you would the test light.
Use DC volts to measure for voltage.
on the sample speed.
Connect the meter just as you would the test light.
Use DC volts to measure for voltage.
#3
TECH Fanatic
Thread Starter
iTrader: (9)
Join Date: May 2005
Location: Longview, TX
Posts: 1,085
Likes: 0
Received 0 Likes
on
0 Posts
I think I must have damaged the coil harness when I bundled it up to shorten it. I can't see how it would be anything else. That is the only other thing I messed with that I'm not 100% positive is not causing the problem. What are the stiff sections in the harness, almost like a fuseable link? It's too late now to go start the car and run any test, it's way too loud.