I hate these threads... but how much power with...
Thread Starter
Staging Lane
Joined: Jun 2005
Posts: 51
Likes: 0
I hate these threads... but how much power with... I'm about to do my first (and rather lage, i think) round of mods to my M6 '99 C5.
MTI stage 2e ls6 based casting heads (milled .030")
--flycut pistons
G5X3 cam from LG
TPIS longtubes
LS6 intake
UD Pulley
Professional full dyno tune
car currently only has borla catback and CAI... nothing substantial but with that and a tune it put down just under 330rwhp
Any estimates on horsepower? I haven't bought the LS6 intake or UD pulley yet, I'm assuming I'll see a pretty big gain with that intake since the rest of the setup will be flowing pretty well, right? I've never bothered with an UD pulley but hell I figure I might as well while I'm in there.
Any other suggestions while I have it apart? Of course I'm replacing the oil pump and timing chain while I'm at it and using all ARP bolts.
MTI stage 2e ls6 based casting heads (milled .030")
--flycut pistons
G5X3 cam from LG
TPIS longtubes
LS6 intake
UD Pulley
Professional full dyno tune
car currently only has borla catback and CAI... nothing substantial but with that and a tune it put down just under 330rwhp
Any estimates on horsepower? I haven't bought the LS6 intake or UD pulley yet, I'm assuming I'll see a pretty big gain with that intake since the rest of the setup will be flowing pretty well, right? I've never bothered with an UD pulley but hell I figure I might as well while I'm in there.
Any other suggestions while I have it apart? Of course I'm replacing the oil pump and timing chain while I'm at it and using all ARP bolts.
