push rod lengths?
Thread Starter
TECH Apprentice
iTrader: (1)
Joined: May 2005
Posts: 335
Likes: 0
From: CAR LENGTHS AHEAD OF YOU
push rod lengths? what length push rod do I need to use with this cam?
232/234 .600/.599 112 lsa
stock heads and stock lower end.
7.4's or 7.375's?
Thanks
Robert
232/234 .600/.599 112 lsa
stock heads and stock lower end.
7.4's or 7.375's?
Thanks
Robert
you might need 7.425's because when you get more lift the base circle on each lobe gets smaller as the lift increases. i have a 228/232 .588/.574 and i need 7.425's stock motor just an fyi you could get by with the 7.4s though might get a little noise
Thread Starter
TECH Apprentice
iTrader: (1)
Joined: May 2005
Posts: 335
Likes: 0
From: CAR LENGTHS AHEAD OF YOU
I was talking to the shop that had the cam. It is a custom ground cam and he said that if I use the 7.4's, the rocker arms wont line up properly. He told me to use the 7.375's. Is he pullin my chain or something?
BTW...the specs are just like in the first post except the durations. Its a 230/233. It also has 7 degrees of overlap on it.
BTW...the specs are just like in the first post except the durations. Its a 230/233. It also has 7 degrees of overlap on it.
Originally Posted by Robinator
I was talking to the shop that had the cam. It is a custom ground cam and he said that if I use the 7.4's, the rocker arms wont line up properly. He told me to use the 7.375's. Is he pullin my chain or something?
BTW...the specs are just like in the first post except the durations. Its a 230/233. It also has 7 degrees of overlap on it.
BTW...the specs are just like in the first post except the durations. Its a 230/233. It also has 7 degrees of overlap on it.
Last edited by MSGHUFF; Feb 3, 2006 at 05:31 PM.
