How much can you bore a LS1 out?
How much can you bore a LS1 out? With darton sleeves how much can you bore the LS1 out? I thought I saw that you could achieve as much as 395cubes just from boring it out. which would be like 4.165 I think, but darton sleeves are sold in 4.125 size. How much would it cost to get this done? Also I know RED in southern california is the only shop people trust around here, but I am in New England and I was wondering if anyone knew a good shop on the east coast.
With a bored out block and a stroker kit where would that put you cubic inch wise?
With a bored out block and a stroker kit where would that put you cubic inch wise?
wet sleeves cost a shitload, and having them installed is another shitload ontop of that.
depends on what you want to get.
With a bored out block and a stroker kit where would that put you cubic inch wise?
thats pretty much all I needed to know. I might as well just get forged pistons and rods, and if I want more power shoot more nitrous.
I have heard of people being able to run 12:1 compression and run Nitrous on pump gass. Anyone know if this is true?
I have heard of people being able to run 12:1 compression and run Nitrous on pump gass. Anyone know if this is true?
is it needed to get aftermarket sleeves?or can the stock be used or get a stock replacement?im going to build a ls1 all forged on boost wanting 600 plus rwhp.wat sleeve do i need for this.theres a shop that for 2200 bucks they do all the block work and install the darton wet seelves,but that alot of money
