Need input on my setup.
#1
Need input on my setup. .030" Gasket?
Here is what I bought.
PRC Stage II Dart's from TSP (I was told are 62cc)
90/90 set up
G5X3 Cam and .030 gaskets.
I was told that ill have to notch the pistons but I was wanting to get CR ~ 11.1. I was told not to mill the heads but instead go with a smaller gasket.
What do you guys suggest?
Is there an advantag going with a smaller gasket and no milling "VS" visa versa?
PRC Stage II Dart's from TSP (I was told are 62cc)
90/90 set up
G5X3 Cam and .030 gaskets.
I was told that ill have to notch the pistons but I was wanting to get CR ~ 11.1. I was told not to mill the heads but instead go with a smaller gasket.
What do you guys suggest?
Is there an advantag going with a smaller gasket and no milling "VS" visa versa?
Last edited by waterbug1999; 04-06-2006 at 09:00 PM.