FBGSU02

iTrader: (6)

I did a LS6 intake swap and now my oil gauge dosent work. my check gauges light stays on and the needle stays at zero. i heard there was something behind the intaje like a sensor or something. what do i need to do to fix this?

also i did a cam swap(MS3) and valvetrain swap and mail order tune. driving around the car is fine but if i go get on it just pushing it to the floor the car gives out and i have to rev it back up to keep it cranked. the rpm's just drop to almost none. but then the cars fine after that. is it b/c theres not a good tune on it?

thunderstruck

iTrader: (15)

you broke the oil pressure sensor. very common. will have to get a new sensor

HASTINGSRJ

iTrader: (18)

yup, the pressure sensor is behind the intake.....on the top of the block in the back. Just be careful when you put your intake back on not to push it too far back.

Z28LS1camaroguy

iTrader: (3)

see that black cylinder thing on the drivers side in the back, http://ls1howto.com/howto/geniii/int...//IMAGE015.jpg thats the sensor.