redline2k

iTrader: (9)

can this block be bored/honed to 3.905 for forged pistons? tried search with no luck.

VA2001SS

I don't know about the bore but it is a 97-mid99 LS1 block with the two small rear oil passage holes instead of one large opening as in later blocks.

Angels512

So is the block bad? I just got one that still has the rotating assembly I took the heads off and lots of burned carbon. Can I just put the heads on after a clean and get my car running before my rebuild later?

CattleAc

iTrader: (7)

In before G Atsma....

G Atsma

Curses.... foiled again.... LOL

Angels512

What?

Che70velle

iTrader: (6)

Long story. You responded to a thread from 06’. Not a big deal, but you’ll likely not get an answer from those guys. GAtsma is the official forum Necro post officer. He makes a point to tell folks such as your self, just how old the thread is and how long it’s been since the original posters have been on here. CattleAC was just messing with GAtsma with his post. It’s all just fun and games at that point.