LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

cam install complete...went very well

Thread Tools
 
Search this Thread
 
Old 04-27-2006, 09:48 PM
  #1  
TECH Fanatic
Thread Starter
 
pla-tym's Avatar
 
Join Date: Oct 2003
Posts: 1,476
Likes: 0
Received 0 Likes on 0 Posts
Default cam install complete...went very well
I installed a XE-R 230/232 .592/.595 113 on a full bolt-on '02 WS6. OEM seals, LS2 chain, Lunati .030 shims, Comp Cams Titanium retainers, 918's, & 7.425 pushrods. Went for a drive to heat cycle the new springs, check all fluids, and everything checked out A-okay so far. Tuning coming soon.
Last edited by pla-tym; 04-29-2006 at 12:30 AM.
pla-tym is offline  
Reply Like
Old 04-27-2006, 09:54 PM
  #2  
TECH Fanatic
iTrader: (2)
 
daryl2cb@yahoo.com's Avatar
 
Join Date: Jul 2004
Location: Greensburg,PA
Posts: 1,882
Likes: 0
Received 0 Likes on 0 Posts
Default
great, not too bad of an install is it. I used the how to instructions, how bout you. get some numbers, I am thinking about upgrading to that cam.
daryl2cb@yahoo.com is offline  
Reply Like
Old 04-27-2006, 10:12 PM
  #3  
TECH Fanatic
Thread Starter
 
pla-tym's Avatar
 
Join Date: Oct 2003
Posts: 1,476
Likes: 0
Received 0 Likes on 0 Posts
Default
I've done 6 cam swaps, and yes I look at the (how to) from time to time.
I will post numbers when I get them.
pla-tym is offline  
Reply Like
Back to Subforum
Generation III Internal Engine
View Next Unread
Weight gain of a 6.0 iron block?




Advanced Search

All times are GMT -5. The time now is 05:34 PM.