Need Help Quick with Katec Rod Bolts
Thread Starter
Launching!
Joined: Jun 2002
Posts: 286
Likes: 0
From: Abilene, Tx
Need Help Quick with Katec Rod Bolts I am in the process of changing to the Katec rod bolts. I have everything down and just took out the first rod bolt. Along with the rod bolt came a threaded insert. Does that insert need to go on the new bolts or can I dicard them?
Any help will be greatly appreciated.
Any help will be greatly appreciated.
Originally Posted by BriGuy
Thank you soooo much!!! That clears everything up.
Thread Starter
Launching!
Joined: Jun 2002
Posts: 286
Likes: 0
From: Abilene, Tx
Man that would suck! To get that far on something and then have something happen to the motor. 
BTW thank you again for your help, the bolts are now in and the car will start going back together tomorrow after I get off of work.
BTW thank you again for your help, the bolts are now in and the car will start going back together tomorrow after I get off of work.
Originally Posted by PREDATOR-Z
Ferrules, discard them and trq 50lbs, that is it.
Do not remove the cap from the rods and only do 1 bolt at a time.
Do not remove the cap from the rods and only do 1 bolt at a time.
