Switching Cams can i keep my pushrods
Thread Starter
TECH Senior Member
iTrader: (48)
Joined: Jan 2002
Posts: 7,354
Likes: 1
From: Columbus, ohio
Switching Cams can i keep my pushrods Ok i have a 224/224-114 .58x cam with hardened pushrods to fit that cam.
If i switched to a 224/220-114 .58x or 226/220-114 .58x (same lift as before) can i keep my push rods or will i need new ones?
If i switched to a 224/220-114 .58x or 226/220-114 .58x (same lift as before) can i keep my push rods or will i need new ones?
Joined: Nov 2001
Posts: 8,484
Likes: 0
From: Cecil County Raceway!!!
Re: Switching Cams can i keep my pushrods it depends if the base circles are the same on the 2 cams. if they are both ground by the same vendor...then most likely you'll be fine
TECH Apprentice
Joined: Jan 2002
Posts: 302
Likes: 0
From: olathe, ks
Re: Switching Cams can i keep my pushrods </font><blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:</font><hr /><font size="2" face="Verdana, Helvetica, sans-serif">Originally posted by smokinHawk:
<strong> Ok i have a 224/224-114 .58x cam with hardened pushrods to fit that cam.
</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">What is the length of your push rod?
<strong> Ok i have a 224/224-114 .58x cam with hardened pushrods to fit that cam.
</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">What is the length of your push rod?
