LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

rocker geometry

Thread Tools
 
Search this Thread
 
Old Aug 9, 2006 | 04:39 PM
Share
  #1  
Rothman's Avatar
Rothman
Thread Starter
TECH Apprentice
iTrader: (4)
 
Joined: Aug 2005
Posts: 399
Likes: 0
From: Hahira, GA
Default rocker geometry
I have done a lot of searching on this subject. I was just wondering how you turn the engine to set the wipe pattern. Aren't you going to be turning against the compression of the engine?
Reply
0
Old Aug 9, 2006 | 04:40 PM
Share
  #2  
vettenuts's Avatar
vettenuts
TECH Senior Member
iTrader: (4)
 
Joined: Jul 2004
Posts: 8,092
Likes: 13
From: Little Rhody
Default
Pull the plugs. Not sure if that's what you meant. I did it on the bench with checking springs.
Reply
0
Old Aug 9, 2006 | 06:09 PM
Share
  #3  
Rothman's Avatar
Rothman
Thread Starter
TECH Apprentice
iTrader: (4)
 
Joined: Aug 2005
Posts: 399
Likes: 0
From: Hahira, GA
Default
duh... sorry my retardation is taking over!
Reply
0
Old Aug 9, 2006 | 06:43 PM
Share
  #4  
vettenuts's Avatar
vettenuts
TECH Senior Member
iTrader: (4)
 
Joined: Jul 2004
Posts: 8,092
Likes: 13
From: Little Rhody
Default
Must be the heat
Reply
0
Back to Subforum
Generation III Internal Engine
View Next Unread
truck coil packs?




Advanced Search

All times are GMT -5. The time now is 09:58 AM.