how to fly cut pistons?
12-07-2006, 06:06 PM
#21
TECH Apprentice
iTrader: (9)
Join Date: Mar 2005
Location: Jamison, Pa
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by The Alchemist
Anyone in the eastern pa area willing to 'mentor' me while doing this? I'm pulling the heads to have some header bolt holes repaired (broke one bolt and stripped two others) and I'd like to go with 0.040" cometics, but am concerned with PtoV clearance. I'll know better when I pull the head and figure out how much they've been milled.
Flycutting the pistons might be a option, but I'd like to have someone looking over my shoulder who has done it once or twice.
I'm in Bucks County PA and plan to do this early January sometime.
Flycutting the pistons might be a option, but I'd like to have someone looking over my shoulder who has done it once or twice.
I'm in Bucks County PA and plan to do this early January sometime.
I'm in the same boat! I did head's/cam/headers/4:10's/Trans/LS7 Clutch in June. I spun a rod bearing in October so I "HAD" to get a new motor that would hold up better. I have a 402 and L92 heads/L76 intake sitting here. Call me at 215-945-6379 if you want to talk.
I also just got cam specs from Patrick G. so It will be an interesting next month or so.
Bob K.
