Sleeves
02-24-2002, 11:27 PM
#1
Teching In
Thread Starter
Join Date: Feb 2002
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Sleeves I'm a student at SAM and am building a big bore ls1. I was wondering what a shop like MTI does to prevent leaking when they hit the water passages during sleeving. The SAM SS hasn't had any trouble with leaking but it is not driven that much and the water temp never gets very high. This motor will be a daily driver so Im a little worried. If it does begin to leak, is there anything I can do short of starting over?
