Replacing Oil Pump, any concerns?
#1
Performance Trucks Sponsor
Thread Starter
iTrader: (5)
Join Date: Jul 2002
Location: san antonio, tx
Posts: 1,439
Likes: 0
Received 0 Likes
on
0 Posts
Replacing Oil Pump, any concerns?
well, after replacing my sensor twice just to be sure i didn't really have low oil pressure, i'm going to replace the oil pump. symptoms are my psi is less than 5psi at idle and 20psi at WOT. i've been driving it like this for about 1,000 miles, i wasn't aware i had low oil pressure. i have a tapping noise coming from the rocker arm area, it goes away when i rev it. any chance i hurt anything?
i'm tearing the engine down tomorrow, anything i should be aware of? i'm sure it will go smooth.
thanks in advance,
allen
i'm tearing the engine down tomorrow, anything i should be aware of? i'm sure it will go smooth.
thanks in advance,
allen
#2
TECH Junkie
Join Date: Nov 2001
Location: Los Angeles
Posts: 3,604
Likes: 0
Received 0 Likes
on
0 Posts
Re: Replacing Oil Pump, any concerns?
Check out the oilpump swap instructions I wrote here: https://ls1tech.com/howto
If you have questions during the install, be sure to post. Its pretty simple.
If you have questions during the install, be sure to post. Its pretty simple.
#3
Launching!
iTrader: (2)
Join Date: Nov 2001
Location: San Diego, CA
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
Re: Replacing Oil Pump, any concerns?
</font><blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:</font><hr /><font size="2" face="Verdana, Helvetica, sans-serif">Originally posted by jmX:
<strong>Check out the oilpump swap instructions I wrote here: https://ls1tech.com/howto
If you have questions during the install, be sure to post. Its pretty simple.</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">Very nice web page!
Clear instructions and good pictures... Good Job!
That page just made it to "my favorites" section.
<img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
<small>[ August 25, 2002, 07:36 PM: Message edited by: BlackHawk ]</small>
<strong>Check out the oilpump swap instructions I wrote here: https://ls1tech.com/howto
If you have questions during the install, be sure to post. Its pretty simple.</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">Very nice web page!
Clear instructions and good pictures... Good Job!
That page just made it to "my favorites" section.
<img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
<small>[ August 25, 2002, 07:36 PM: Message edited by: BlackHawk ]</small>