Head stud torque suggestions
Thread Starter
Teching In
Joined: Dec 2001
Posts: 40
Likes: 0
Head stud torque suggestions hey all, im just interested on some of your suggestions on torque settings on a LS1 with cometic head gaskets, ARP 190,000 psi head studs. The engine is 382 cubed with about 10.5 comp. I used ARP's moly lube.
Thanks, Matt
Thanks, Matt
TECH Fanatic
Joined: Nov 2001
Posts: 1,975
Likes: 2
From: SW Florida
Re: Head stud torque suggestions ARP head stud torque values are in this thread >
https://ls1tech.com/ubb/ultimatebb.p...c;f=1;t=007171
https://ls1tech.com/ubb/ultimatebb.p...c;f=1;t=007171
Thread Starter
Teching In
Joined: Dec 2001
Posts: 40
Likes: 0
Re: Head stud torque suggestions Doh! thanks Dude, i just found it! it pays to look hey, sorry.
Just on the topic, does anyone else have an opinion or experiance with this, i thought we could have cranked them up a bit more than 65ft/pds or am i just getting stuck in the "old days" of cast iron V8's...remember them?? Ha Ha Ha.
Just on the topic, does anyone else have an opinion or experiance with this, i thought we could have cranked them up a bit more than 65ft/pds or am i just getting stuck in the "old days" of cast iron V8's...remember them?? Ha Ha Ha.
