Re-torqueing head gaskets
Thread Starter
LS1Tech Sponsor
iTrader: (12)
Joined: Nov 2001
Posts: 14,865
Likes: 6
From: Bridgewater,Ma
Re-torqueing head gaskets I install some Cometic gaskets and ARP head studs over the weekend and I'm wondering if I should retorque them now they have heat cycled.To do this I'd have to pull the headers off and intake to get to all the bolts.What do you think?
TECH Fanatic
Joined: Nov 2001
Posts: 1,986
Likes: 1
From: Centrifugal City
Re: Re-torqueing head gaskets 1st time around as new, Cometic says 'No Heat Cycle' 'Single TQ set'.
Dunno about re-use, but I bet they say the same. You could call.
<small>[ September 09, 2002, 10:47 PM: Message edited by: MelloYellow ]</small>
Dunno about re-use, but I bet they say the same. You could call.
<small>[ September 09, 2002, 10:47 PM: Message edited by: MelloYellow ]</small>