Bob2of3

iTrader: (11)

ITs been since last Sept that I had a running engine <img border="0" title="" alt="[Sad]" src="gr_sad.gif" /> Been trying to pick all the parts that I'll need or wanted to upgrade along with getting everything I already had to install when the engine eat that damn nut. So its been a while since I've actually accomplished anything. Although I didn't really make a dent in whats needed to complete this project its starting off pretty good.

Rings didn't need any filing to get into spec, Main and rod clearances were all between .0026-.0031 and I got the pistons assemblies back together and waiting on getting all the cam bearings back in to fill the holes. I finish the cam bearing either tonight or tomorrow then the short block should take shape very quickly after that

Almost there <img border="0" alt="[Fluffy]" title="" src="graemlins/fluffy.gif" />

LAter <img border="0" title="" alt="[Big Grin]" src="gr_grin.gif" />

DONAIMIAN

iTrader: (18)

what parts did you upgrade

JPR

Thats terrific Bob! please call me tommorow, have an idea.

Joe.

<small>[ October 06, 2002, 08:08 PM: Message edited by: JPR ]</small>

JS

iTrader: (4)

Hope to see u up and running at Atco real soon Gilligan
Should run some serious numbers once its setup to run

Good luck Bob
JS