Will I run into problems with......(Cam Question)
Thread Starter
Launching!
Joined: Nov 2001
Posts: 228
Likes: 0
From: Warner Robins, GA
Will I run into problems with......(Cam Question) Will I run into problems running a cam around 228 .58x 112 with 5.7 heads running 2.02/1.57 valves milled .035? Also would I run stock length push rods or .05 shorter rods?
Thanks
Thanks
TECH Addict
Joined: Dec 2001
Posts: 2,298
Likes: 2
From: new england
Re: Will I run into problems with......(Cam Question) Cam base circle determines need for pushrod length change, it appears you would be ok with stock length with heads milled. TTT on PTV question.
Thread Starter
Launching!
Joined: Nov 2001
Posts: 228
Likes: 0
From: Warner Robins, GA
Re: Will I run into problems with......(Cam Question) Thanks LS1 <img border="0" alt="[cheers]" title="" src="graemlins/gr_cheers.gif" />
Did I ask a stupid question or what? I searched and searched but did not come up with what I'm looking for.
Did I ask a stupid question or what? I searched and searched but did not come up with what I'm looking for.