what do these heads flow in stock form?
Thread Starter
*Bad Trader*
Joined: Nov 2001
Posts: 1,459
Likes: 0
From: here and there
what do these heads flow in stock form? 5.3 5.7 6.0
im just curious as to how they flow in stock form compared to each other
<small>[ October 12, 2002, 05:43 PM: Message edited by: Grinch ]</small>
im just curious as to how they flow in stock form compared to each other
<small>[ October 12, 2002, 05:43 PM: Message edited by: Grinch ]</small>
10 Second Club
Joined: Jun 2002
Posts: 1,884
Likes: 4
From: H-town
Re: what do these heads flow in stock form? i though i remember someone posting that the 5.3 and 5.7 were very close and that the 6.0 was slightly more. i do have a flow sheet that someone posted on 6.0 head versus the LS6 head. the 6.0 had better low lift numbers but the LS6 had superior high lift numbers. hope this helps. hey man are your 5.3 heads in yet. cant wait to see it back on the street again.
TECH Addict
Joined: Dec 2001
Posts: 2,298
Likes: 2
From: new england
Re: what do these heads flow in stock form? 5.3 heads flow less than 5.7 heads because of smaller valves and chamber area. When ported i see 5.7 heads do usually flow more than ported 5.3 also.LS6 and 6.0 heads seem to flow the most ported, it sure seems like comb. chamber crowding of valves sets the potential limits of heads.
<small>[ October 14, 2002, 07:55 AM: Message edited by: LS1derfull ]</small>
<small>[ October 14, 2002, 07:55 AM: Message edited by: LS1derfull ]</small>
