Just ordered heads/cam
Thread Starter
TECH Apprentice
Joined: Jun 2002
Posts: 360
Likes: 0
Just ordered heads/cam Below is my new setup, tell me what you think!
GM CNC Ported 6.0 liter heads
2.02 x 1.55 valves
283 @ .600 intake 239 @ .600 exhaust
Comp Cams Magnum Lifters
Rev Stainless 5 angle valves
Comp Cams Titanium Retainers
Comp Cams 941 Springs
Comp Cams 226/232 .568/.568 112 LSA Cam
10.8:1 Compression, 6800 redline
NGK TR-55 @ .050
Taylor Race Plug Wires
GM 28lb Injectors
MMS Dyno Tuned PCM
100 shot NX (questionable)
The bottom end is remaining stock.
<small>[ October 14, 2002, 02:49 PM: Message edited by: bo0oost ]</small>
GM CNC Ported 6.0 liter heads
2.02 x 1.55 valves
283 @ .600 intake 239 @ .600 exhaust
Comp Cams Magnum Lifters
Rev Stainless 5 angle valves
Comp Cams Titanium Retainers
Comp Cams 941 Springs
Comp Cams 226/232 .568/.568 112 LSA Cam
10.8:1 Compression, 6800 redline
NGK TR-55 @ .050
Taylor Race Plug Wires
GM 28lb Injectors
MMS Dyno Tuned PCM
100 shot NX (questionable)
The bottom end is remaining stock.
<small>[ October 14, 2002, 02:49 PM: Message edited by: bo0oost ]</small>
Re: Just ordered heads/cam Sounds like a winner.. If I may ask.. How much were your heads? The GM CNC LS6 Lingenfelter heads flow 295cfm @ .525 lift.. Right now they are on sale... That is a killer deal..
