oil pressure wanring light question
Thread Starter
TECH Senior Member
iTrader: (9)
Joined: Dec 2001
Posts: 5,395
Likes: 1
From: Estero, FL
oil pressure wanring light question Is anyone using the autometer wanring light for oil pressure? If you are, how did you set it up? I have been trying to figure out how I can build a fitting so I can run my stock oil pressure sender, an autometer mechanical oil pressure guage and the warning light. Has ANYone done this?
HELP!!!!!
HELP!!!!!
Re: oil pressure wanring light question Leave the stock sender where it is.
There is an aluminum block that bolts to the oil pan, just about the oil filter. It can be drilled and tapped for getting oil pressure.
I run mechanical oil pressure and temperature, as well as turbo oil feed from that location.
Here's info on it from another install, mid-page
http://xse.com/leres/ss/gaugepod.html
There is an aluminum block that bolts to the oil pan, just about the oil filter. It can be drilled and tapped for getting oil pressure.
I run mechanical oil pressure and temperature, as well as turbo oil feed from that location.
Here's info on it from another install, mid-page
http://xse.com/leres/ss/gaugepod.html
