Problem with my crank? flywheel?
Problem with my crank? flywheel? Hey all. i just finished my new engine build. but now i have run into a problem.
ok heres the deal:
flexplate is too far out that starter won't reach it.
stock 98 flexplate
stock '02 crank
'02 LS6 block
brand new starter (stock one didint reach suddenly either, then it hit the dust)
ok heres the deal:
flexplate is too far out that starter won't reach it.
stock 98 flexplate
stock '02 crank
'02 LS6 block
brand new starter (stock one didint reach suddenly either, then it hit the dust)
also if i flip the flexplate backwards and stick some washers behind it i can get the engine to crank over beautifully. but when put on correctly, starter won't reach the flexplate ?!
thanks alot. now, if i got a flat flex plate, would that still work out? like p/n 12551367 from the 6.0L ? or would that not work with my 4l60e converter/trans? seems as though i need a flat flexplate to work.
Last edited by GrandmasterCow; May 18, 2007 at 01:51 AM.
