themack56

iTrader: (70)

i have a 98 z28, i bought the car when it had about 50,000 miles, it currently has 106,000, the engine pulls as hard as when i bought it, but i was wondering why when i rev up my car at about 1500 to 3000 my steering wheel vibrates alot, after 3000 it calms down a bit, is it my engine mounts? or what i have no idea, plz help

blueeyeddevil141

iTrader: (5)

Any mods to the car? Is the steering knuckle/shaft touching the header/block?

themack56

iTrader: (70)

stock besides, slp cold air intake

blueeyeddevil141

iTrader: (5)

Hmm, take a look near the steering components, make sure nothings hitting it. Any problems when driving the car?

themack56

iTrader: (70)

besides, my alignment being off, its steers to the left, when i let the wheel go, i realy dont know what it is

Blk97WS6

iTrader: (19)

Check the trans mount. I had the same problem in my LT1, and a new mount took care of it. You should have seen how nasty the stocker was. Barely any rubber left.

Lt1Porsche

iTrader: (6)

I did some research and found that a vibration within that rpm range is very common for our cars. I also have the same vibration. I would still check all mounts and make sure everything is clear but if nothing is found dont worry much about it. Use the search button. Its in a few posts.

3.4camaro

iTrader: (1)

That's probably the resonant frequency of the car. You could swap motor mounts. I have solids. The whole car torques to the side when i gas it.

themack56

iTrader: (70)

ill replace the tranny mount and ill check the motor mounts