I am wanting to go with the magic stick 4. I have a 6.0 block with patriot stage 3 heads, heads have been slightly milled... My question is am i gonna need to get my pistons cut? or should this work with it being a 6ltr?

and if so how much relief should i need? and whats a round about on how much that would cost to get done..

 

I'm very sure you need to Flycut your Pistons with any Milled Heads with MS4.

 

thats what i was thinkin.. thanks bud. i think im gonna do it any way for the extra insurance ya know.. should have this installed within the next week or week and a half

 

maybe not? how dished are the stock 6.0 pistons??

 

not very much.. i was told by someone that they came with some valve relief but they are dished very slightly.. not sure how much.. im not even sure how much i relief i need tho

 

t.t.t