compression/ptv
compression/ptv K i don't need to go into nobel prize winning detail so here are the specifics.
i already have a torquer v.2 232/234 .595/.598 113+0.
looking @ getting some PRC 5.3 Stg. 2.5s from TSP w/ 2.02/1.60 valves. chamber size 62.5 but may get them milled.
keeping compression in mind as here in the TX panhandle we carry only 90 oct., some have 91. With that in mind I'm trying to piece together my setup w/ as much knowledge as possible, w/ possible milling of the heads for smaller chambers and potential gasket sizes (cometic head gaskets btw)
So in short what is basically the ceiling for me on the compression, SCR, on 90-91 oct, and what chamber size/gasket size will I need.
Sorry to make this so long, just trying to get my ducks in a row before I purchase my heads and get the swap in motion.
i already have a torquer v.2 232/234 .595/.598 113+0.
looking @ getting some PRC 5.3 Stg. 2.5s from TSP w/ 2.02/1.60 valves. chamber size 62.5 but may get them milled.
keeping compression in mind as here in the TX panhandle we carry only 90 oct., some have 91. With that in mind I'm trying to piece together my setup w/ as much knowledge as possible, w/ possible milling of the heads for smaller chambers and potential gasket sizes (cometic head gaskets btw)
So in short what is basically the ceiling for me on the compression, SCR, on 90-91 oct, and what chamber size/gasket size will I need.
Sorry to make this so long, just trying to get my ducks in a row before I purchase my heads and get the swap in motion.
