New project for me.......
Thread Starter
11 Second Club
iTrader: (29)
Joined: May 2006
Posts: 1,933
Likes: 1
From: The Bayou State
New project for me....... Came in today from Vengeance Racing. It's there VRX4 cam. I also have all the extra cam swap stuff, but this is the crown jewel:
The wait is finally over. Now it's time to get dirty and see what she'll do. Hope to get a dyno before and after, but no promises. What do ya'll think?
The wait is finally over. Now it's time to get dirty and see what she'll do. Hope to get a dyno before and after, but no promises. What do ya'll think?
Good choice on the Vengeance cam. I'm going with one of their cams in the fall too. Vindicator most likely. 
Thread Starter
11 Second Club
iTrader: (29)
Joined: May 2006
Posts: 1,933
Likes: 1
From: The Bayou State
I'll definately revive this thread when I'm done. Moving into the new house next week so it'll be the first week in August when I start on it. I almost want to postpone the move until after, but the wifey says otherwise lol. I think I will like this cam. It's right in the middle which is where I wanted to be. Do ya'll think some P&P 241 heads would work good with it or should I not waste my time and go with some 5.3's?
