Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

ticking question

Thread Tools
 
Search this Thread
 
Old 08-17-2008, 09:29 PM
  #1  
On The Tree
Thread Starter
iTrader: (4)
 
00ssmg's Avatar
 
Join Date: Jun 2007
Location: JOLIET
Posts: 157
Likes: 0
Received 0 Likes on 0 Posts

Default ticking question

hi all i have a 2000 ss camaro cam only...its a tr230 with oil pump double roller, 7.4s and prc dual golds....my question is that i have a ticking noise pretty much all the time...nothing loud just sounds like a lifter noise i can even hear it when driving next to my car. I have about 2500 miles on it and have change the oil once after about a thousand miles...The oil did look a little bit grey like metal...but nothing bad...magnet on the drain plug had little to nothing on it and i even cut open the oil filter and little to no metal there..pen magnets in the oil and filter came out clean...(was just trying check with them) thunder racing told me some noise would be normal due to the fast ramp rate of the cam..i was hoping that pat g or someone could chime in and help out..was running ams oil and now running royal purple..car runs good and havent had any issues just worries me...any help would be great as this is now my dd
Old 08-18-2008, 09:00 PM
  #2  
On The Tree
Thread Starter
iTrader: (4)
 
00ssmg's Avatar
 
Join Date: Jun 2007
Location: JOLIET
Posts: 157
Likes: 0
Received 0 Likes on 0 Posts

Default

no one can chime in on this one. any help would be great
Old 08-18-2008, 09:52 PM
  #3  
TECH Addict
iTrader: (31)
 
sroach20's Avatar
 
Join Date: Dec 2002
Location: houston, Texas
Posts: 2,318
Likes: 0
Received 1 Like on 1 Post
Default

did you measure to see what size pushrods you were supposed to use or just stick the 7.4s in and go?
Old 08-19-2008, 06:26 PM
  #4  
On The Tree
Thread Starter
iTrader: (4)
 
00ssmg's Avatar
 
Join Date: Jun 2007
Location: JOLIET
Posts: 157
Likes: 0
Received 0 Likes on 0 Posts

Default

just stuck 7.4s in and went. i ordered my pushrod length checker i just dont know how to measure lifter preload or use the checker put im sure the checker will have instructions
Old 08-19-2008, 06:35 PM
  #5  
TECH Addict
iTrader: (31)
 
sroach20's Avatar
 
Join Date: Dec 2002
Location: houston, Texas
Posts: 2,318
Likes: 0
Received 1 Like on 1 Post
Default

i had to use 7.425 to get mine to shut up.
Old 08-19-2008, 07:39 PM
  #6  
Staging Lane
 
dadem0n's Avatar
 
Join Date: Aug 2006
Posts: 68
Likes: 0
Received 0 Likes on 0 Posts
Default

is it definately valvetrain noise?

not an exhaust leak is it?




All times are GMT -5. The time now is 07:25 AM.