Which Rods and compstar I beam rods anything one use them?
#1
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Nov 2007
Location: NJ
Posts: 1,193
Likes: 0
Received 0 Likes
on
0 Posts
Which Rods and compstar I beam rods anything one use them?
Well was going to use a set of K1 Rods might still use them just not sure looking for ideas? Going in a high hp boost/FI heavy car?
The Compstar I-Beam Connecting Rod are they much better ? anyone use them yet?
t
The k-1 and H beam compstar i believe to about the same or equal at least right?
Whats the next step over the compstar or k-1 with out alot of cost ?
The Compstar I-Beam Connecting Rod are they much better ? anyone use them yet?
t
The k-1 and H beam compstar i believe to about the same or equal at least right?
Whats the next step over the compstar or k-1 with out alot of cost ?
#2
Tenured Member
iTrader: (3)
Join Date: Nov 2002
Location: Ohio
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
The I-Beams aren't available yet..... still a few weeks off.
We do have our H-I rods available, which is a heavier duty rod than our original H-Beam. These are good for higher boost and larger nitrous applications.
They aren't on our website right now. I'll be launching our new site later next week, and they will be on there. Until then, there's some info in this post about them:
New Compstar H-I Rod
We do have our H-I rods available, which is a heavier duty rod than our original H-Beam. These are good for higher boost and larger nitrous applications.
They aren't on our website right now. I'll be launching our new site later next week, and they will be on there. Until then, there's some info in this post about them:
New Compstar H-I Rod