ls2 intake on GM900 truck
Thread Starter
Banned
Joined: Feb 2010
Posts: 25
Likes: 0
ls2 intake on GM900 truck IM about to mount ported ls2 intake on my GM900 trucks,
this was the best place i could find to post my questions.
Since my truck is GEN IV ls2 based, the intake should be pretty much basic swap w/out major modifications.
This intake has 2 plastic tubes on each side, right behind the throttle body entry, where exactly do these go connected to?
also do the connector on the back: connec to the valley cover,
im going to be running ls7 valley cover, any help would be appreciated.
this was the best place i could find to post my questions.
Since my truck is GEN IV ls2 based, the intake should be pretty much basic swap w/out major modifications.
This intake has 2 plastic tubes on each side, right behind the throttle body entry, where exactly do these go connected to?
also do the connector on the back: connec to the valley cover,
im going to be running ls7 valley cover, any help would be appreciated.
On my LS2 Goat, there is a "loop" hose that comes off of a metal nipple on the valley cover, and loops back to the passanger side of the intake, right behind the TB. That would be the nipple that is visable in your picture there. The one on the driver side goes to an emissions soleniod that mounts on the front of the passanger head, and then back to a hard line on the firewall. It can just be blocked off. Not sure on the rear, and my car is 5 hours away right now.
